Charging - Samsung POWERbot SR1AM7040W Série Guide D'utilisation

Charging

After completely charging the POWERbot for the first time (after purchase), it can be used for 60
min. in Nomal ( ) mode. (Refer to the page 39 for the charging time.)
Smart Charging
If the POWERbot's charge runs low while it is in Auto clean mode, it will automatically return to
the docking station to recharge, and then will return to the cleaning area after its battery is 2/3rds
charged. (Maximum: 2 times.)
1
Turn on the
emergency switch
on the bottom
You must turn on the
emergency switch to turn on
the POWERbot.
Press and release the
button.
2
Manually charge
the POWERbot by
placing it in the
docking station
Make sure the charging
pins on the POWERbot
and the docking station
are aligned.
ENGLISH-12
• Rated input voltage of
this product is 100-
WARNING
240 V~.
<SR1AM7010UW Series>
<SR1AM7040W✴ /
SR2AM70✴✴✴✴ Series>
3
Check the charging
status
For the SR1AM7010UW Series, the battery
indicator blinks at 1 second intervals
during charging. The indicator will remain
on when the battery is fully charged.
For SR1AM7040W✴ / SR2AM70✴✴✴✴ Series,
each section of the "
successively to indicate charging progress and
"FULL" will appear when charging is complete.
" will turn on