Samsung POWERbot SR1AM7040W Série Guide D'utilisation page 9

Before use
CAUTION
f Insert the dustbin before using the
POWERbot.
f For proper automatic recharging, do the
following:
– Always turn on the power of the docking
station.
– Install the docking station where the
POWERbot can find it easily.
– Do not leave any object in front of the
docking station.
f When installing the docking station, do
not leave the cord on the floor where the
POWERbot can run over it.
f Do not use POWERbot on black colored
floors.
– The POWERbot may not be able to operate
normally.
f Do not place any objects within 1.6 ft
(0.5 m) of either side of the docking
station or within 3.3 ft (1 m) of the front
of the docking station.
f Make sure the docking station's charging
contact is not damaged and is free of
foreign matter.
f Do not install the docking station in an
area with a dark floor.
– If the floor around the docking station is
dark, recharging is hindered.
f Move any obstacles that may disturb
POWERbot's movement (such as a
children's indoor swing or slide) before
cleaning.
f Do not use the POWERbot in a place
which is narrower than its turning radius
(1.6 ft/0.5 m or less).
f To clean all areas of your house, open all
rooms and attach the boundary markers
to places where the POWERbot could get
damaged such as a front door, veranda,
bathroom, or stairs.
f For areas with low clearance where
the POWERbot may get stuck, attach
the boundary markers to prevent the
POWERbot from getting in.
CAUTION
f Using the POWERbot on thick carpet may
damage both the POWERbot and the
carpet.
– The POWERbot cannot pass over carpet that
is thicker than 0.4 in (1 cm).
f Do not use the POWERbot on tables or
other high surfaces.
– There is a risk of damage if it falls.
f The POWERbot may bump into chair or
desk legs. Move them out of the away for
faster, more efficient cleaning.
f When the POWERbot is operating, do not
lift it up or carry it to another area.
f Do not hold the POWERbot by its driving
wheels when carrying it to another area.
f Do not put any objects on top of the
POWERbot and camera since this may
cause the POWERbot to malfunction.
f Remove any large pieces of paper or
plastic bags from the area to be cleaned
before using the POWERbot since they
may block the POWERbot's intake.
f Do not aim the red pointer directly at
people or animals.
f Do not lie down near the POWERBOT
when it is running.
– Your hair may be caught in the brush,
resulting in physical injury.
CAUTION
f To prevent any damage to the POWERbot:
– Do not clean the POWERbot by spraying
water directly onto it or using benzene,
thinner, acetone or alcohol to clean it.
f Do not disassemble or try to repair the
POWERbot yourself. Repairs should only
be done by a certified repairman.
f Always keep the obstacle sensor, cliff
sensor, and camera clean.
– If foreign matter accumulates, the sensors
may malfunction.
ENGLISH-09
In use
Cleaning and
maintenance