First Start - CTC Wireless room sensor Instructions D'installation Et D'entretien

12.3

First start

• First check the software version of the heat pump. Go to
the "Installer" menu. At the bottom of the menu, the date of
the software version display card is displayed. This must be
20120712 (09/06/2012) or later. If the software is older than
this, it must be upgraded before installing the room sensor.
Contact your CTC installer to fi nd out how to do this.
• Start the room sensor. Open both the panels on the sides and
insert the two AAA alkaline batteries supplied. If the batteries
are already fi tted, remove the insulating tape. Close the panels.
The room sensor is now operating.
• Activate the wireless room sensor in the display. Go to the
"Installer/Defi ne system" menu and choose the radiator system
that you want the sensor to control.
Choose Room sensor = "Yes" and Type = "Wireless".
• Move down to "Room sensor: Connect" and press "OK". The
cursor moves to the word "Connect". Press "OK" again. The
system now waits for the room sensor to communicate with the
heat pump.
English
Installer
Time/Language Settings Defi ned system Service
Software display PCB: 20130530 v116
Software HP PCB: 20130503
Def heating circuit
Radiator system Yes
Room sensor Yes
Type Wire
Def heating circuit
Radiator system Yes
Room sensor Yes
Type Wireless
Action Association
Status Dissociated
Level of signal
Battery 85 %
Version
CTC Wireless room sensor
EN
31