Positioning - CTC Wireless room sensor Instructions D'installation Et D'entretien

English
12.2

Positioning

• Mount the connection box inside the front panel below the
display using the foam tape fi xed to the back of the box.
• Mount the antenna in a position where good reception is
guaranteed using the double-sided adhesive tape supplied.
Hint: Do not attach the antenna permanently until you have
made certain that it can send and receive radio signals.
NB: The position of the antenna has a signifi cant effect on the
signal strength. Do not place the antenna on sheet-metal or
metal parts; other wireless devices can also interfere with the
signal.
• The heat pump display shows the signal strength. You can use
this when you are trying out a suitable position.
• Mount the room sensor in a central location in the house after
the system has started up. The sensor will control the heat
levels to ensure that the required temperature is reached. Do
not put the sensor in a draughty place or near a heat source.
EN
Turn off the operating switch before installing the
!
CTC Wireless Room Sensor.
30
CTC Wireless room sensor
Do not place the an-
!
tenna on sheet-metal
or metal parts; other
wireless devices can
also interfere with the
signal.
Def heating circuit
Radiator system Yes
Room sensor Yes
Type Wireless
Action Association
Status Dissociated
Level of signal
Battery 85 %
Version