Connecting Sonorolight; Connecting The Headphones; Setting The Basic Functions; Switching On The Device For The First Time - Sonoro SO-220 Mode D'emploi

3. Close the battery compartment.

7.6 Connecting sonoroLIGHT

In order to be able to control a lamp using the Blue-
tooth function, you must connect sonoroLIGHT and
sonoroCD 2 once. Connected devices are stored and
later connected automatically.
i
Follow the sonoroLIGHT operating instructions.
1. Plug sonoroLIGHT into a socket.
2. Ensure that sonoroLIGHT and sonoroCD 2 are no
more than 10 m away from one another. Other-
wise, no connection can be established.
3. Press the button on your sonoroLIGHT.
ð sonoroLIGHT searches for another Bluetooth
device.
4. Press the [Light] button on your sonoroCD 2 and
hold it for 3 seconds.
ð The devices are connected to one another.
No password needs to be entered. Once the
devices are successfully connected, the
[Light] button lights up in white.
5. Connect a lamp to the socket on your sonoro-
LIGHT.

7.7 Connecting the headphones

The headphones can be connected to the device with
the 3.5 mm stereo jacks (not included in the
package).
L WARNING!
Risk of injury from improper headphone use!
Improper use of headphones can cause severe
accidents and damage to health.
– Do not set the volume too high when using the
headphones.
– Ensure that children understand that too high a
listening volume can lead to hearing damage.
1. Turn the click wheel to the left to set the volume
to minimum.
2. Insert the headset jack into the headset port at
the back of the device.
3. Slowly turn the click wheel to the right to
increase the volume.
8

Setting the basic functions

The individual menus let you select the functions and
settings of the device.

8.1 Switching on the device for the first time

After you have switched the device on for the first
time, the LC display shows the clock display and the
message [Tune to FM RDS station to set time & date].
i
In FM/DAB mode, time and date are set automati-
cally as long as this has not been disabled.

8.2 Standby mode

You can adjust the following settings in standby
mode:
n Manually set the time.
n Manually set the date.
n Switch the date on the display on/off.
n Setting alarm light (only with sonoroLIGHT).
Ä Chapter 8.3 'Making the basic settings'
on page 60
The procedure for setting the individual functions is
the same.
Setting the time manually
Fig. 12: Setting the time
1. Press the [SETUP] button on the device or the
remote control in Standby mode.
ð The display shows [Set Time] (Fig. 12).
2. Press the click wheel to set the hours.
ð The hour display flashes.
3. Turn the click wheel to set the hours.
4. Press the click wheel to confirm the setting.
ð The minute display flashes.
5. Turn the click wheel to set the minutes.
59