Parameter Settings - BONFIGLIOLI Vectron ACTIVE ACT 201 3,0 Guide De Démarrage Rapide

Note:
In the case of higher requirements as regards the accuracy of the speed/torque control, you should carry out the
guided commissioning procedure once again under operating conditions because part of the machine data
depends on the operating temperature.
During this procedure, confirm the rated values for the machine data already entered.
• Confirm the "End" display by pressing the ENT key.
The guided commissioning of the frequency inverter is terminated via a reset and the initiali-
zation of the frequency inverter. The relay output X10 signals a fault.
After successful initialization of the frequency inverter, the factory-set parameter
quency
S2IND (start clockwise operation) or at digital inputs S1IND (controller release) and S3IND
(start of anti-clockwise operation), the drive is accelerated to the adjusted
418 (default value 3.50 Hz).
4

Parameter settings

The parameters displayed in the PARA menu branch are partly set via the guided commissioning.
Additional Configurations with further parameter settings are described in the operating instructions manual.
Control Level
ters of the higher control levels 2 or 3 are described in the operating instructions and should be
set up by expert operators only.
Setting:
Configuration
of the software modules is selected by the configuration. The selection is made during the guided
commissioning.
Setting:
Program(ming)
knowledged (alternative to signal at digital input S1IND).
Setting:
Motor type
values and the guided commissioning are carried out on the basis of the parameterized motor
type.
Setting:
Rated Voltage
Setting:
Rated Current
tor.
Setting:
30
30
241 is displayed. If a signal is present at digital inputs S1IND (controller release) and
28 - The brief instructions describe the parameters in control level 1. The parame-
1 ... 3
30 - The basic function of the control inputs and outputs as well as the assignment
110 - sensor-less control with U/f characteristic for speed regulation in a great
number of standard applications
410 - sensor-less, field-oriented control, for applications with a high functionality
and dynamics
34 - The factory settings of all parameters is restored or a fault message is ac-
4444 Activate factory settings
123 Acknowledge fault message
369 – Setting of connected motor or transformer. The verification of the entered rated
0 - Unknown
1 - Asynchronous Three-phase asynchronous motor, squirrel cage
2 - Synchronous
3 - Reluctance
10 - Transformer
370 - Enter the voltage indicated on the type plate of the asynchronous motor.
60.0 V ... 800.0 V
371 - Enter the rated current indicated on the type plate of the asynchronous mo-
0.01⋅I ... 10⋅o⋅I
FIN FIN
The motor is not a standard type.
Three-phase synchronous motor
Three-phase reluctance motor
Transformer with three primary windings
Actual Fre-
Minimum Frequency
06/07
06/07