Clock Adjustment - Teac LT-1 Manuel Du Propriétaire

DISPLAY
1
2
3
4
5
6
7
8
36
. m , /
MEMORY/CLOCK ADJ

Clock Adjustment

1 Press the DISPLAY button to select clock display.
":" blinks in the clock display.
< If the unit is off, press and hold the MEMORY/CLOCK
ADJ button for 2 or more seconds, and continue the
procedure from step
3
< Press the STOP button to cancel the time setting. (In
the TUNER mode, press the DISPLAY button.)
2
Within 4 seconds, press and hold the
MEMORY/CLOCK ADJ button for 2 or more seconds.
3 Press the .m or ,/ button to select
"12H" or "24H".
If you select "12H", "AM" or "PM" appears on the
display.
< In the TUNER mode, use the TUNING knob.
4
Press the MEMORY/CLOCK ADJ button.
5 Press the .mor,/ button to set the
current hour.
< In the TUNER mode, use the TUNING knob.
6 Press the MEMORY/CLOCK ADJ button.
7 Press the .mor,/ button to set the
current minute.
< In the TUNER mode, use the TUNING knob.
8 Press the MEMORY/CLOCK ADJ button to finish the
time setting mode.
The clock starts from 00 second.
< If the unit is disconnected from the power supply for
more than 3 minutes, the clock and timer setting will
be reset.
< If the unit is disconnected for less than 3 minutes
the time displayed may not be correct.
ENGLISH
.