Num'axes EXPERT 600 Guide D'utilisation page 23

 Activate/deactivate the collar with the remote control
A magnet located in the remote control is used to switch the EXPERT receiver collar On or Off.
- Activate: move the remote control towards the collar so that the magnet position indicator comes into
contact with the red mark on the collar, hold for 1 second (ref. Diagram 5). The green indicator light
on the collar will flash indicating that the collar is On.
- Deactivate: move the remote control towards the collar so that the magnet position indicator comes
into contact with the red mark on the collar, hold for 1 second (ref. Diagram 5). The green indicator
light on the collar flashes quickly then goes out indicating the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a
long period.
Place these two areas
together for 1 second
 Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no other
person is using his EXPERT 600 or other products from the NUM'AXES range close by: your receiver
collar could accidentally record the code of his remote control. If that occurs, re-code the remote
control with the receiver collar.
Gb - 23
Diagram 5
Activate/deactivate the receiver
collar with the remote control