Horizon Hobby Arrma 4x4 3S BLX Vehicle Mode D'emploi page 16

If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
If the ESC temperature exceeds 105 degrees Celsius/221 degrees Fahrenheit, the ESC will
enter temperature protection mode and the green status LED will blink. Once the ESC has
The ARRMA BLX brushless ESC is setup for use straight from the factory, if you want to alter the
settings for your track or driving style please see the table and steps below:
Variable
1
2 Punch Setting
3 Brake Strength
4 Running Mode
5 Motor Rotation
A
1. Connect a battery. Press and
hold the set button and turn on
4. Using the tuning chart, press
the 'set' button until the number
beeps equals the required value.
To reset the ESC to factory default settings, connect a battery, turn the transmitter on and then turn
the car on. Press and hold the set button for 4 seconds and release. The Red and Green lights will
Setting > 1
LIPO
Level 1
25%
Fwd/Brk/Rev
Normal Reverse
(CCW)
B
2. Keep holding the set button
and you will see the GREEN
variable number).
5. To save the setting,
the process to make more
changes.
2 3 4
NIMH
Level 2 Level 3 Level 4
37.5% 50% 62.5%
Fwd/Brk
(CW)
3. To enter the selected
variable, release the set button
on the desired number of
16
5 6 7
Level 5
75% 87.5% 100%
WWW.ARRMA-RC.COM