Selections; Options; Status - Alliance Laundry Systems DRY725C_SVG Guide De L'utilisateur

Operating Your Dryer
Manual
There are three manual cycles: Time Dry, Quick Dry and Fluff Up.
These cycles will run for the set number of minutes shown on the
digital display. The cycle time can be increased or decreased using
the up and down arrow keypads. The time and temperature selec-
tion may be adjusted manually at any time before or during the cy-
cle.
Favorite
The Favorite cycle keypad allows the user to save different cycles,
selections and options for later use. Nine favorite cycles can be
saved.
1. Press the Favorite keypad. The control will display the cycle and
modifier settings for the first Favorite cycle. The 2-digit display
will switch between F1 and the cycle time for the selected cycle.
2. Press the keypads for the desired cycle, selection and option
settings.
3. Press the Favorite keypad to save the settings. The next Favor-
ite cycle, F2, will be displayed. It can be programmed now.
4. Press the Start/Pause or Delay Start keypad to save the set-
tings and start the cycle.
5. Press the Power/Cancel keypad to discard the current settings
and exit Favorite mode.
Power
AUTO-SENSING
MANUAL
Cancel

Selections

The following selections can be used to modify the currently chosen
cycle. The default selections will be lit after choosing a cycle.
Temp
Press the Temp keypad to change a Manual cycle' s temperature.
Choose from No Heat, Low, Medium or High.
Dryness
Press the Dryness keypad to change the dryness level in an Auto-
Sensing cycle. Choose from Damp, Less Dry, Near Dry or Dry.
Damp
Less Dry
Near Dry
Dry
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Heavy
Duty
Favorite
DRY2755N_SVG
Leaves load slightly damp for
easier ironing.
Use for lightweight items such
as sheets and shirts.
Use for normal loads.
Use for heavy items such as
blue jeans and blankets.
Over-drying can cause wrinkling, shrinking, excessive lint conditions,
and will use more energy than necessary. To increase energy savings
and to make sure loads are dried without over-drying, set your Au-
to-Sensing loads on Near Dry or Less Dry. If items are damp or
over-dry at the end of a cycle, increase or decrease the Dryness
setting the next time these loads are dried. Remember the settings
that work best to get ideal drying results.
Moisture Level
The Moisture Level status lights will be lit during an Auto-Sensing
cycle. The Sensing light will be lit at the beginning of the cycle.
The Wet, Damp and Dry lights will be lit based on readings from the
moisture sensing system.

Options

The following options can be used to modify the currently chosen
cycle, signal volume and control lock.
Anti-Wrinkle
This option prevents wrinkling by tumbling the clothes load after
the end of the cycle every two minutes for up to 60 minutes. The
display will show the time remaining. The option will end if the door is
opened.
EcoDry
The EcoDry option will reduce total energy consumption by de-
creasing the temperature of the cycle setting by 10% after the ini-
tial temperature setting has been reached.
Signal
Pressing the Signal keypad will change the end of cycle signal vol-
ume. There are four settings: Off, Low, Medium, High.
If the Anti-Wrinkle option is selected the signal will sound each time
the dryer tumbles.
Control Lock (Secure keypad)
Pressing and holding the Signal keypad for three seconds will turn
on the Control Lock. The Control Lock status light will be lit. While
Control Lock is on, no other keypad presses are allowed. Press and
hold the Signal keypad again to turn the option off.

Status

The Status lights are lit during the cycle to show what part of the
cycle is running.
Door Open
12
The Door Open status light is lit
any time that the dryer door is
open.
Table continues...
Part No. D516314ENR1