What's Included; Installing The Main Unit; Installing The Gps Antenna - Garmin GVN60 Instructions D'installation

What's included

GPS antenna and
metal plate
hook-and-loop
fasteners (2)

installing the Main unit

Use the screws or the hook-and-loop fasteners provided to mount the main unit in the vehicle. Select a location that allows you to
access the SD card slot on the unit.
Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, or liquids.
Check for cables or other parts underneath the floor mat before cutting the floor mat.

installing the gPS antenna

Do not paint the antenna. This will impair or disable signal reception.
Remove any object or accumulated snow, etc., from the top of the antenna. It will reduce reception strength.
Do not pull the cord when removing the antenna or adjusting its position. This can cause a short or break the wires.
The permanent adhesive on the back of the metal plate is extremely difficult to remove after it is installed.
The GPS antenna can be installed either inside or outside the vehicle. It should be mounted horizontally for best GPS reception.
The GPS antenna must have a clear view of the sky. If you install the antenna inside the vehicle, place it close to a window. GPS
signals can pass through glass but not through metal. Refer to the image on the next page for recommended places to install the
antenna. Place the GPS antenna on a metallic surface, such as the roof of your vehicle, for best reception. If a metallic surface is not
available, mount the GPS antenna on the enclosed metal plate. See the next page for further instructions.
installing the FM antenna
Notice
For best reception, position the antenna in the
vertical orientation. Keep the last several feet of
the FM antenna several inches away from any
metal object or structure.
The FM traffic antenna should be installed
inside the vehicle. Plug the FM antenna socket
into the FM antenna connector on the GVN60.
Completely deploy the antenna to its full length. See the diagram on the next page for more information.
main unit M3 x 12 machine
screws (4)
M3 nuts (4)
owner's manual installation manual
Windshield
Dashboard
FM antenna connector
FM Antenna Installed Vertically
M3 x 12 thread-
forming screws (4)
warranty card
Caution

Caution

FM antenna
GVN60
- 2 -
wiring harness
FM antenna
FM antenna
FM antenna connector
FM Antenna Installed Horizontally
Windshield
Dashboard
GVN60