Nailing Tab Installation - Napoleon Vector Serie Manuel D'installation

important:
If the front frame was removed, it must be reinstalled prior to installing the nailing
tabs.
1
Remove the screws from the appliance.
DO NOT DISCARD.
3 Type 1 (x2)
Secure to the upper front frame using 2 screws (supplied).
TO INSTALL NAILING TABS FOR SEE-THRU APPLIANCES, REPEAT STEPS WITH THE OPPOSITE SIDE.
note:
See "venting", "electrical information" and "gas installation" sections prior to fi nish framing.
IMPORTANT:
Do NOT remove the knockouts
unless installing Dynamic
Heat Control™. If damaged
or removed without Dynamic
Heat Control™, appliance will
overheat and will cause a fi re
hazard.

nailing tab installation

9.0 nailing tab installation
2
Align the nailing tab with the holes on the appliance, secure
with the screws in step 1.
TOP VIEW
4
EN
X X
X X
47
W415-2034 / C / 04.21.21