Hendi 209905 Mode D'emploi page 7

Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning & storage.
Cleaning
• Clean the appliance before and after each use.
• Never immerse the appliance in water or other
liquids.
• Do not clean the appliance with a water jet.
• Flush the tap and the liquid level indicator thor-
oughly.
• Clean the surface with a slightly damp cloth or
sponge with some mild soap solution.
Descaling
• Hard water may cause some deposits to form in-
side the container and cause possibly damage to
the appliance.
• Thus, descale the appliance regularly. The des-
caling intervals depend on water hardness and
frequency of use. Use only commercially availa-
ble descaling agents and follow the instructions
of the manufacturer.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Defects
Defect Problem
Appliance does not Neither green on/off
work at all. light nor indicator light
is illuminated.
Boiler switches off The orange light is il-
automatically. luminated.
Boiler does not Green light is not
reach the selected illuminated.
temperature.
Cause
No mains power.
Boiler has exceeded maxi-
mum safety limits. Dry boil-
ing protection is activated.
Thermostat does not work.
Heating element does not
work.
When in doubt always contact your supplier!
• All washed parts should be rinsed with clean wa-
ter to remove the cleaning residues.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
- Fill the container with water and appropriate
amount of descaling agent up to MAX level.
- Start boiling the solution.
- After boiling, dispose of the solution of water
and descaling agent properly.
• Rinse the container and boil twice to remove any
residues.
• Store the appliance in a cool, clean and dry place.
Possible solution
Check the electrical con-
nections.
Unplug & let it cool down
for 15 ~ 20 minutes. Then,
plug it and restart again.
Contact your supplier.
EN
7