Scheppach 19013 04901 Traduction Des Instructions D'origine page 25

Fig. "Q"
2
Fig. "Q1"
1
4
315
mm
inch
mm
+
110
4
100
90
80
3
70
60
2
50
40
-
30
1
20
10
1
0 0
3
2
5
Starting operations
Please read the safety instruc- tions before setting
the saw bench into operation.
All protective and auxiliary devices must have been mounted.The
scheppach Precisa 6.0 is ready for operation when it has been
connected to the mains.
NOTE:
In accordance with valid product liability laws, the
manufacturer of this device shall not be responsible for
damage to and from this device which results from:
• lmproper care
• Noncompliance with the Operating Instructions
• Repairs made by unauthorized persons
• The installation and use of any parts which are not original
scheppach replacement parts.
• lmproper use and application
• Failure of the electrical system as a result of
noncompliance with the legal and applicable electrical
directives and VDE regulations 0100, DIN 57113 / VDE
0113
Sawblade height adjuctment
Sawblade angle adjustment
Fig. "Q"
• The height is adjusted simply by turning the hand wheel "1" left
or right.
• With a sawblade Ø 315 mm read off the height to which the
blade has been adjusted on the left-hand scale.
• Sawblade Ø 315 mm = Cut depth from 0 - 110 mm
• The height is adjusted simply by turning the hand wheel "2" left
or right.
• For adjusting the sawblade angle setting (max. 45") pull out
the hand wheel with both hands and hold firmly. Release
the lock handle (1).
• Set the desired angle by turning the hand wheel.
• To return to 0° turn the hand wheel back until the end stop
is reached.
Switch
Fig. "Q1"
1 - On/off switch saw blade
2 - Kick switch (only with scoring attachment)
3 - On/off switch prescoring device
4 - Main switch /only with 4,8 kW motor)
5 - Phase inverter (when changing the power suppy line or
the location it is necessary to proof the directon of
rotation, if necessary polarity must be changed)
english 25