Mounting - Scheppach 19013 04901 Traduction Des Instructions D'origine

Fig. "A"
Fig. "B"
Fig. "F"
Fig. "G"

Mounting

All assembly and retrofitting work may only be performed when the
mains plug has been disconnected.
Your scheppach circular sawbench is not completely assembled for
packaging reasons.
Assembly tools
The following are included in the scope of delivery:
1 open-end spanner
1 open-end spanner
1 allen key
1 allen key
1 allen key
Parallel fence Fig. "A"
Screw the fence section, in-between plate and guiding slide
together. For this purpose, insert the threaded bolts in the
guiding slide.
4 intermediate bushes
4 cheese head screws
Fig. "B"
Attach the intermediate plate to the fence section.
- Do not tighten -
2 cheese head screws
2 washers
2 wing nuts
Parallel fence adjustment
Fig. "F"
• Open the extender lever on the sliding table (pull upwarts)
and put it condescendingly on the guide tube
For precise adjustment of the parallel fence in relation to the
circular saw blade, release the four cheese head screws (1),
and clamp the guide slide at a distance of approx. 100 mm
from the blade. Place a straight slat of approx. 600 mm length
against the blade. Align the fence parallel with the saw blade
by repeated measurement (X) and readjustment. Retighten the
cheese head screws (1)
Important!
For cutting widths below 120 mm always use a push stick.
Stop rail
Fig. "G"
Position 1:
For working with raised stop bar surface. The displayed cut
width is on the black display scale.
Position 2;
For working with lowered stop bar sur- face.
The displayed cut width is on the blue display scale. (Lower
stop bar surface symbol)
19 mm width across flats
30 mm width across flats
5 mm width across flats
6 mm width across flats
4 mm width across flats
M 6 x 40
M 6 x 75
6
M 6
english 21