Eskimo WIDE1 Inferno Manuel De L'utilisateur page 9

TRAVEL POSITION
11
Locate the front extension assembly
(#27539), and skin (#15507). Unfold the
skin, and make sure the extension assembly is
in the "travel" position. Locate the metal loops
on the front of the shelter, and slide them
onto the extension assembly.
13
Drape the shelter skin over the top of the
frame. Start by lifting the rear of the shelter
skin over the top of the front frame support.
Make sure that you are evenly working the
shelter skin over the supports. Continue
working the shelter skin over the rest of the
frame supports until the shelter skin lies
evenly over the entire shelter.
NOTE: Attaching the skin can be a difficult task
and is easiest with two people to ensure proper
installation and desired fit.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
IN-USE POSITION
#28462
#27539
12
Attach the extension arms (#28462) to the
front extension assembly (#27539) with (2)
1 inch bolts, (2) plastic washers, and (2)
-1/2
bolts as shown in FIGURE 12.
14
Once the shelter skin is on the frame, move to
the inside of the shelter and attach the hook
and loop retainers to the frame supports.
15
After attaching all of the hook and loop
retainers you are ready to install the edge trim
to the rear of the shelter. Move to the outside
of the shelter and start by identifying the edge
trim piece (#69654) from the parts box. Locate
the center of the edge trim piece by folding it
in half. Line up the center of the edge trim to
the best of your ability with the center of the
rear of the shelter.
Operator's Manual
ESKIMO
WIDE1 Inferno
® ™
9