Eskimo WIDE1 Inferno Manuel De L'utilisateur page 10

skirt
edge trim
sled
16
Pull the skin taut and push the edge trim over
lip of the sled with the shelter skin between the
two. It is important to keep the skin taut and
work the edge trim evenly around both sides
of the shelter until all edge trim is in place. SEE
FIGURE 13.
NOTE: When pulling the shelter skin tight, DO NOT lift
the lower frame support off the ground. Make sure all
spreader poles are properly installed before the edge
trim is attached to ensure a proper fit. Using a rubber
mallet may be helpful while attaching the edge trim
to the sled lip.
10
17
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
#6 - 3/8" screw
edge trim
Secure the edge trim in place using the
(13) #6 x 3/8 inch sheet metal screws
provided. A cordless drill and Phillips head
bit is recommended for this step, but is not
necessary. SEE FIGURE 14.
NOTE: Screws should be spaced evenly apart. This
step does mean you will put very small holes in your
shelter skin to keep the edge trim and skin securely
attached to the sled lip. This will in no way affect the
performance of your shelter.
Operator's Manual
ESKIMO
WIDE1 Inferno
® ™
skin
sled