Shelter Set-Up And Take-Down Instructions; Long-Term Storage - Eskimo WIDE1 Inferno Manuel De L'utilisateur

ADDITIONAL INSTALLATION
TOW ROPE
Locate the included 8 foot tow rope that was in the
hardware bag. To install the tow rope locate the two
holes in the front of the sled and push each end of
the rope through a hole. Tie a knot at each end of
the rope to keep the rope from pulling through the
holes. This tow rope is designed for manual pulling
by hand only. DO NOT tow behind a motorized
vehicle with rope. For high-speed towing, you
should purchase the Eskimo Universal Tow Hitch
accessory (#11608).
GEAR NET
Included with your Eskimo Wide1
to keep you organized on and off the ice.
To install the gear net (#15596) to the sled attach
the hook and loop retainers to the rear seat rail
(#15033). After attaching the gear net to the seat
rails, locate the 24 inch piece of edge trim along
with the remaining edge trim screws used earlier.
Secure the gear net by attaching it to the front
of the sled lip with the edge trim and edge trim
screws. SEE FIGURE 15 BELOW.
Gear Net
Edge Trim
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
Inferno is a gear net
™
SET-UP / TAKE-DOWN
Extend the front pole assembly to the "in use"
position (SEE FIGURE 11) before flipping the shelter
over. The front pole should fall to the bottom of the
slot in the hinge when in use.
To take-down the shelter, collapse the front pole
to the "travel" position (SEE FIGURE 11), and flip
the poles over the shelter, pulling the front pole
assembly to the top of the slot in the hinge.
On breezy but otherwise nice days, the front pole
assembly can be extended to the "in use" position
and flipped up halfway (leaving the front pole at
the bottom of the slot in the hinge) to form a wind
break.
NOTE: Use caution so you don't rip or tear the skin,
especially around the hinges or any pinch point
areas.
NOTE: An Eskimo Travel Cover (16475) may
be purchased to protect your shelter while
transporting to and from the lake.

LONG-TERM STORAGE

• Always make sure your ice shelter is completely
dry before storing for long periods of time.
Storing your ice shelter when damp or wet may
cause mold and mildew damage.
• Remove skin from ice shelter sled and poles.
• Clean all salt, moisture and debris from your
shelter skin, sled and poes. Wipe down poles
with a wet rag.
• Store skin, poles an sled in a cool, dry place away
from rodents.
NOTE: Lubricate the slide poles with a silicon spray
at least seasonally. Do not use oil or grease as a
lubricant.
Operator's Manual
ESKIMO
WIDE1 Inferno
® ™
11