Assembly; Tools Needed - Eskimo WIDE1 Inferno Manuel De L'utilisateur

ASSEMBLY INSTRUCTIONS

TOOLS NEEDED:

• (2) 7/16" wrenches and/or socket driver
• Phillips head screwdriver
• Rubber mallet (optional)
• Cordless drill (optional)
IMPORTANT ASSEMBLY TIP
DO NOT FULLY TIGHTEN ANY NUT AND BOLT COMBINATION
UNTIL INSTRUCTED IN LATER NOTES. THIS WILL HELP WITH HOLE
ALIGNMENT FOR ALL PARTS.
1
(A) Attach (#27825) and (#11631) to (#15502)
sled with (2) 3/4 inch bolts, (2) nuts, and (3)
washers as shown in FIGURE 1.
(B) Repeat step 1a for remaining (#27825) on
the other side of the sled (#15502) as instructed
above.
6
#15502
#27825 #11631
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
ASSEMBLY TIPS:
• This ice shelter should be assembled in an indoor setting due to the
time and length of assembly. Identify and familiarize yourself with all
parts and hardware before assembly. Allow 1-2 hours for assembly.
• The use of a cordless drill with socket will make assembly of your ice
shelter much quicker. Be sure to set the drill speed on low so you do
not over tighten any nut and bolt combination.
• If a tracking kit is purchased with the shelter it should be mounted to
the sled before assembly of the ice shelter for convenience.
#27825
#11203
SEE DETAIL
2
Attach the (2) hinge support straps (#11203) to
the hinges (#27825) and sled (#15502) with (4)
1 inch bolts, (4) washers, and (2) nuts as shown
in FIGURE 2.
NOTE: If the hole alignment is off or looks too far apart,
rotate the hinge support brace and try again. This part
will only bolt on one way.
Operator's Manual
ESKIMO
WIDE1 Inferno
® ™