Black & Decker LHT2436 Mode D'emploi page 6

Masquer les pouces Voir aussi pour LHT2436:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• disconnect the charger from the outlet before attempting any
cleaning. This will reduce the risk of electric shock. Removing the
battery pack will not reduce this risk.
• NeVer attempt to connect 2 chargers together.
• The charger is designed to operate on standard household electrical
power (120 Volts). do not attempt to use it on any other voltage.
SAVe THeSe INSTrUCTIONS
IMPOrTANT SAfeTy wArNINgS
fOr BATTery PACkS
wArNINg:
For safe operation, read this manual and
manuals originally supplied with tool before using the charger.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below.
Then follow charging procedures outlined.
reAd ALL INSTrUCTIONS
• do not incinerate the battery pack even if it is severely
damaged or is completely worn out. The battery pack can
explode in a fire. Toxic fumes and materials are created when
battery packs are burned.
• do not charge or use battery in explosive atmospheres,
such as in the presence of flammable liquids, gases or dust.
Inserting or removing the battery from the charger may ignite the
dust or fumes.
• If battery contents come into contact with the skin,
immediately wash area with mild soap and water. If battery
liquid gets into the eye, rinse water over the open eye for 15
minutes or until irritation ceases. If medical attention is needed, the
battery electrolyte for Li-ion batteries is composed of a mixture of
liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory irritation.
Provide fresh air. If symptoms persist, seek medical attention.
wArNINg:
Burn hazard. Battery liquid may be flammable if
exposed to spark or flame.
• Charge the battery packs only in Black & decker chargers.
• dO NOT splash or immerse in water or other liquids. This may
cause premature cell failure.
• do not store or use the tool and battery pack in locations
where the temperature may reach or exceed 105°f (40˚C) (such
as outside sheds or metal buildings in summer).
wArNINg:
Never attempt to open the battery pack for any
reason. If battery pack case is cracked or damaged, do not insert
into charger. Do not crush, drop or damage battery pack. Do not use
a battery pack or charger that has received a sharp blow, been
dropped, run over or damaged in any way (i.e., pierced with a nail,
hit with a hammer, stepped on). Damaged battery packs should be
returned to service center for recycling.
wArNINg:
fire hazard. do not store or carry battery so
that metal objects can contact exposed battery terminals. For
example, do not place battery in aprons, pockets, tool boxes, product
kit boxes, drawers, etc., with loose nails, screws, keys, etc.
Transporting batteries can possibly cause fires if the battery
terminals inadvertently come in contact with conductive
materials such as keys, coins, hand tools and the like. The US
Department of Transportation Hazardous Material Regulations
(HMR) actually prohibit transporting batteries in commerce or on
airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS
they are properly protected from short circuits. So when transporting
individual batteries, make sure that the battery terminals are
protected and well insulated from materials that could contact them
and cause a short circuit. NOTE: LI-ION batteries should not be
put in checked baggage.
6

Publicité

Table des Matières
loading

Table des Matières