Black & Decker LHT2436 Mode D'emploi page 10

wArNINg:
Remove battery pack before servicing, cleaning or
removing material from the gardening appliance.
The cutting blades are made from high quality, hardened steel and
with normal usage, they will not require resharpening. However, if you
accidentally hit a wire fence (figure 9), stones,
glass or other hard objects, you may put a nick in
the blade. There is no need to remove this nick as
long as it does not interfere with the movement of
the blade. If it does interfere, remove the battery
and use a fine toothed file or sharpening stone to
remove the nick. If you drop the trimmer, carefully
inspect it for damage. If the blade is bent, housing
cracked, handles broken or if you see any other
condition that may affect the trimmer's operation
contact your local Black & Decker Service Center
for repairs before putting it back into use.
Fertilizers and other garden chemicals contain agents which greatly
accelerate the corrosion of metals. Do not store the unit on or
adjacent to fertilizers or chemicals.
With the battery removed, use only mild soap and a damp cloth to
clean the unit. Never let any liquid get inside the unit; never immerse
any part of the unit into a liquid. Prevent the blades from rusting by
applying a film of light machine oil after cleaning.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
9 NOTe: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority
to operate the equipment. This Class B digital apparatus complies
with Canadian ICES-003.
10