Alesis QX25 Guide D'utilisation Rapide page 8

TROUBLESHOOTING
PROBLEM
The display does not light up.
No sound from target device.
Notes sustain continuously.
CAUSE
No power.
QX25 not properly
connected.
QX25 connected after
software application has
started.
Problem is caused by use of
a USB hub.
Software application not set
to receive MIDI data from the
QX25.
QX25's MIDI channel not the
same as application's
incoming MIDI chanel.
Sustain pedal was plugged or
unplugged after the QX25
was powered on.
Stuck notes due to
incomplete MIDI data.
Please make sure that the QX25 is connected to your
computer and that the computer is powered on.
If using a power adapter, please make sure that the
adapter is plugged into a live power outlet.
Check your computer's USB connection to confirm that
the QX25 is recognized.If necessary, replug the
connection and restart your computer.
If controlling an external hardware module, make sure
that the MIDI cable is connected from the QX25 to the
device's MIDI IN port.
Restart the software application with the controller
plugged in.
Unplug the QX25 from the USB hub and connect
directly to the computer.
Ensure that the QX25 or USB MIDI device is listed as
an active MIDI source in your application. Usually, the
MIDI settings can be accessed through the
application's Preferences menu.
Make sure that the QX25 is sending MIDI information
on the channel that the target device expects.
Press Transport << and >> simultaneously to send a
MIDI panic message, which resets all controls and
sends an All Notes Off message. If that does not work,
turn the unit's power off, wait a moment and then turn it
on again.
8
SOLUTION