Hendi 265109 Mode D'emploi page 5

• Use the screw to adjust the height of the chev-
ron The closer to the knife, the thinner the slices.
(Fig. 2)
After use
• Turn off the appliance and remove the plug from the main socket.
Maintenance
• Before cleaning, always turn the switch (A) to the
"off" position and remove the plug from the main
socket.
• Clean the outside of the housing with a damp
cloth and a non-corrosive liquid.
• Remove the top part of the housing (Fig. 1)
Troubleshooting
Problems
Appliance does not do anything
Technical specification
Item no.: 265109
Operating voltage and frequency: 230V~ 50Hz
Rated input power: 135W
Remark: Technical specification is subjected to change without prior notification.
Fig. 2
• Remove the knife and the chevron Attention! The
knife is very sharp.
• The knife, the chevron and the upper part of the
housing are dishwasher proof.
• Dry the appliance thoroughly before re-assem-
bling it.
Cause
No mains voltage.
The upper part of the housing has
not been installed properly. The
safety mechanism makes sure the
appliance does not start.
Protection class: Class I
Dimension: 230 x 185 x (H) 325mm
Possible solution
Check the electrical installation.
Make sure the housing is in-
stalled properly using
screws.
EN
the
5