Connecting To A Wired Network; Playing Audio Using Play-Fi - Martin Logan Motion Vision X Manuel De L'utilisateur

without needing to enter a password. WPS is not
a standard feature on all routers, and only one
wireless device can be set up at a time.
Check your router's owner's manual to see if WPS
is an available feature, or look for a button on your
router marked with the WPS logo (
does not have WPS, then use the Access Point
Wireless Setup.
1. For optimal setup conditions place your soundbar
next to your wireless router. The soundbar can
be moved to its final location after wi-fi setup
2. Plug in your soundbar and press the Power button.
3. The Wi-Fi Setup and Status button will start
rapidly blinking for 20 seconds while your
soundbar boots. If this is the first time your
new soundbar is plugged in, the Wi-Fi Setup
and Status button will start pulsing slowly. If
the soundbar is already configured to connect
to a wi-fi network, the button will turn solid
(connected) or blink rapidly (not connected).
4. For 3 seconds, press the soundbar's Wireless
Setup and Status button until you hear a tone.
The soundbar will display "WF.SETUP" and
after a few seconds the Wi-Fi Setup and Status
button will blink twice in continuous intervals
to indicate WPS mode. At any time you can
press the Wi-Fi Setup and Status button again
to cancel the setup mode.
P a
layIng udIo
Note: Future updates to the DTS Play-Fi application
may change functionality.
1. Launch the DTS Play-Fi app on your mobile
device or PC (located in the system tray).
). If your router
u P ‑F
sIng lay
5 Now push the WPS button (
6. Once the Wi-Fi Setup and Status button is solid (not
blinking), this indicates your soundbar is connected
to the wireless network. This may take up to a
minute. If, after a minute, the button continues to
blink rapidly, setup failed and you should try again.
7. Connect your mobile device or PC to the
same network as your soundbar. Launch the
DTS Play-Fi
®
automatically detect your soundbar and should
prompt you to name your soundbar.

CONNECTING TO A WIRED NETWORK

1. Using an Ethernet cable, connect your soundbar
to your router.
2. Plug in your soundbar and press the Power button.
3. The Wi-Fi Setup and Status button will start
rapidly blinking for about 20 seconds while
your soundbar is booting up.
4. The Wi-Fi Setup and Status button turns off
when the soundbar is connected via Ethernet.
5. Connect your mobile device or PC to the
same network as your soundbar. Launch
the DTS Play-Fi app. Upon launching, it will
automatically detect your soundbar and should
prompt you to name your soundbar.
I
2. Android and iOS Device Users: Within the
Play-Fi app, select your music source. You can
choose from your personal music library, Internet
Radio, or from select internet music services. PC
Users: Any audio content from your computer
can be streamed using Play-Fi.
) on your router.
app. Upon launching, it will
17