Horeca Select GGW1001 Mode D'emploi page 25

6.3 Total discharge at end of workday
At the end of service, after having carried out the final discharge and the eventual regeneration, turn off
the machine by pushing the on/off button
interception tap. Do not leave the inactive unit turned on and unused for any periods of time
long or short.
Cycle running, the cycle warning lamp lights up. If during
the cycle, the door is opened for over 3 seconds the
programme stops. When the door is closed again the
programme reset to zero. To restart push the cycle
button again.
Upon termination of the programme the cycle warning
lamp turns off and the boiler warning lamp lights
up .
Unload the rack
Total discharge at end of workday (models with discharge
pump)
Open the door, remove the over flow pipe and close the door.
Turn the machine off by pushing the on/off button
discharge pump will come on for about 100 seconds until the
tank is completely emptied. During the discharge of the tank
the cycle warning lamp will light up to signal that the tank
discharge is running.
To make the machine operative again it is therefore necessary
to replace the over flow pipe in the tank close the door and
push the on/off button
service, turn off the main switch on the wall.
Total discharge at end of workday (models without
discharge pump)
Turn off the machine by pushing the on/off button
the door and remove the over flow pipe, and wait for the total
emptying of the tank. Replace the over flow pipe and close the
door again. Turn off the main switch on the wall.
PLEASE NOTE: during discharge the tank cleaning cycle will
come on automatically for about 20 seconds.
, turn off the main switch on the wall and close the water
, or else in the event of an end of
:
the
, open