First Start-Up; Preparation For Use - Horeca Select GGW1001 Mode D'emploi

FIRST STARTUP
The electrical protection system must be subjected to a functional test before use. The installation must be
performed and/or verified by the authorized retailer who will be responsible for the first startup and for the
instructions relative to the dishwasher's operation.

PREPARATION FOR USE

Important:
The rinse-aid dosing unit (3) is always present in all models
while the detergent dosing unit (1) is present in only few .
If both dosing units are present, position the external
detergent and rinse-aid containers and insert their respective
suction tubes located at the back of the machine.
Red tube: detergent
Transparent tube: rinse-aid
Before inserting the tubes into the containers, apply the
weights (necessary to keep the tubes at the bottom of the
container) and the filters as indicated in the diagram (2).
For adjustments, use the adjustment screws indicated in the diagram. It is
recommended the adjustments be performed by personnel from the companies who
have supplied the detergent products.
If the detergent metering unit did not come pre-installed, it can be installed by ordering
the relative KIT at a later time.
Alternatively, an external dosing unit can be connected by means of an electrical
connection with a 2x0.5 mm type H05 RN-F cable. This cable must be inserted through
the passage indicated in the TECHNICAL CHARACTERISTICS scheme and connected
in accordance with the electrical scheme furnished with the dishwasher.
The dosing unit must be 230V/50Hz with a maximum absorbed power of 15W.
Connect the external detergent dosing unit to the dishwasher through the red tube cited above.
on/off button symbol
Wash cycle button symbol
Led indicator light
functions
5 FIRST STARTUP ( Installer )
6 MECHANICAL MODEL USER INSTRUCTIONS
GGW1001
GGW2001
Regeneration button symbol
Drain pump button symbol
Boiler rinse led indicator light symbol