Power Function; Timer - Novy 1756 Mode D'emploi Et D'installation

Power function

The power function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high power.
The power is foreseen for example to heat up rapidly big quantities of water, like nuddles
cooking.

Start up / Stop the power function:
Action
Zone selection
Start up the power
Stop the power

Power management:
The cooking hob is equipped with a maximum of total power. When the power function is
activated, and not to exceed the maximum power, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed :
Heating zone selected
[ P ] is displayed

Timer

The timer can be used simultaneous with all 3 heating (according to the model) zones and this
with different time settings (from 0 to 99 minutes) for each heating zone.

Setting and modification of the cooking time :
Example for 16 minutes at power 7 :
Action
Zone selection
Select the power level
Select « Timer »
Set the units
Valid the units
Set the tens
Valid the tens
The time is confirmed and the cooking starts.

To stop the cooking time:
Example for 13 minutes at power 7 :
Action
Zone selection
Select « Timer »
Deactivate the units
Valid the units
Deactivate the tens
Valid the tens
Control panel
press key [ 0 ] from the zone
press key [ P ]
slide on the "SLIDER"
or press on [ P ]
The other heating zone:
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
press display [ 0 ]
slide on the "SLIDER" to [ 7 ]
press display [ CL ]
slide on the "SLIDER" to [ 6 ]
press display [ 06 ]
slide on the "SLIDER" to [ 1 ]
press display [ 16 ]
Control panel
press display [ 7 ] selected
press key [ 13 ]
slide on the "SLIDER" to [ 0 ]
press display [ 10 ]
slide on the "SLIDER" to [ 0 ]
press display [ 00 ]
55
Display Zone
[ 0 ] and control light on
[ P ]
[ P ] to [ 0 ]
[ 9 ]
(example: power level 9)
Display
[ 0 ] and control light on
[ 7 ]
[ 00 ]
[ 0 fixed ] [ 6 blinking ]
[ 0 blinking ] [ 6 fixed ]
[ 1 blinking ] [ 6 fixed ]
[ 16 ]
Display
[ 0 ] and control light on
[ 13 ]
[ 1 fixed ] [ 0 blinking ]
[ 1 blinking ] [ 0 fixed ]
[ 0 blinking ] [ 0 fixed ]
[ 00 ]