Wolf icbwwd30 Instructions D'installation page 15

I N S TA L L AT I O N I N S T R U C T I O N S
C A B I N E T S U P P O R T S
IMPORTANT NOTE: When the warming
drawer is installed with a built-in oven,
additional clearance between openings may be
required. Check that oven supports do not
obstruct the interior dimensions required for
the warming drawer.
The warming drawer with stainless steel
drawer front may be supported by either a
solid platform, 51 mm x 51 mm runners or
51 mm x 102 mm runners. The platform or
runners must be level, rigidly mounted and
flush with the bottom edge of the opening.
They must be able to support 91 kg.
If an integrated drawer front is used, it must be
supported by a 16 mm solid platform. The
platform will need to be recessed and allow for
overlap of the warming drawer collar. Refer to
page 18 for additional details. The platform
must be level, rigidly mounted and must be
able to support 91 kg.
IMPORTANT NOTE: Make sure that the
platform or runners are level. There is no way
to level the warming drawer once it has been
installed.
U N PA C K T H E W A R M I N G D R A W E R
Unpack the warming drawer on a flat surface.
Remove all packaging materials and tape from
inside the warming drawer and discard. Do not
discard the package containing the two wood
screws needed for installation.
15