Wolf icbwwd30 Instructions D'installation page 11

I N S TA L L AT I O N I N S T R U C T I O N S
I N T E G R AT E D D R A W E R F R O N T
O V E R L AY A P P L I C AT I O N
A minimum 838 mm wide by 610 mm deep
cabinet is required for the warming drawer
with integrated drawer front using the overlay
application. A minimum base support of 91 kg
is required. Refer to the illustration on page 10.
I N S E T A P P L I C AT I O N
IMPORTANT NOTE: The inset application
requires the warming drawer to be recessed
into the cabinet. A minimum 635 mm deep
cabinet is needed if you want the front panel
to be flush with surrounding cabinetry.
If you are installing the warming drawer with
integrated drawer front in an inset application,
a minimum 838 mm wide and 635 mm deep
cabinet is required for this installation. A
minimum base support of 91 kg is required.
Refer to the illustration below.
Integrated Drawer Front – Inset Application
U N D E R C O U N T E R I N S TA L L AT I O N
For undercounter installations, 597mm from
the bottom of the warming drawer opening to
the floor is recommended. It must be installed
a minimum of 127 mm above the floor or
25 mm above the toe kick.
The Wolf warming drawer with integrated
drawer front may be installed below a 762 mm
or 914 mm wide electric or gas cooktop,
provided the warming drawer is fully enclosed,
top and bottom. Refer to installation instruc-
tions for the cooktop for additional specifica-
tions. Dimensions will vary according to the
specific installation.
11