Remote Control; Possible Solutions - Masterbuilt MES Série Instructions D'utilisation

Operating Instructions

REMOTE CONTROL

To replace batteries:
• Slide belt clip to the left to remove. Press tab down on battery cover and pull out.
• Install 2 AAA alkaline batteries. Check positive (+) and negative (-) symbols on the case and battery to
GENERAL DRAWING NOTES:
1. BREAK SHARP EDGES .003-.010 INCHES (.08-.25 MM)
2. DIMENSIONS SHOWN ARE IN INCHES [MM]
ensure proper installation. Replace the battery cover.
3. MATERIAL: --
4. WEIGHT: --
• Remove batteries before storing remote control.
To test frequency range:
• Turn smoker on. Use remote to turn light on and off as you move away from smoker.
• Remote control is out of frequency range when light will no longer turn on and off. Remote control has
frequency range of up to 100ft (30m). Test frequency range before and during use.
IMPORTANT:
• Do not leave remote control exposed to sunlight for prolonged periods of time.
Troubleshooting:
• If the remote is not working properly or not interfacing correctly with the controller, it may be due to weak
batteries, incorrect battery installation or the remote is not correctly linked to controller.

Possible solutions:

• Replace batteries and install according to image in battery housing.
• Link controller and remote:
1. Turn controller and remote ON.
2. Press and hold SET TEMP on controller for 3 seconds.
3. On the remote, press MEAT PROBE, LIGHT, MEAT PROBE, LIGHT (all buttons must be pressed
within 5 seconds of each other). A short beep will occur after each button is pressed.
• Keep batteries away from small children. If battery is swallowed consult a physician immediately.
• Be sure to insert batteries correctly. Improper installation may result in leaks and/or possible explosion.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
• Do not mix old and new batteries.
• Do not dispose of batteries in fire.
(If featured)
GENERAL DRAWING NOTES:
1. BREAK SHARP EDGES .003-.010 INCHES (.08-.25 MM)
2. DIMENSIONS SHOWN ARE IN INCHES [MM]
3. MATERIAL: --
4. WEIGHT: --
CAUTION
*Batteries not
included
General Tolerance
THE INFORMATION
CONTAINED IN THIS
STANDARD METRIC
DRAWING IS THE SOLE
X.
N/A 1
PROPERTY OF
X.X
0.030 0.80
MASTERBUILT
X.XX
MANUFACTURING. 0.015 0.40
ANY X.XXX 0.005 0.10 --
TITLE:
REPRODUCTION IN
X/X 1/32 N/A
PART OR AS A WHOLE
Degree 1° 1°
WITHOUT THE WRITTEN
Unless Otherwise Specified
PERMISSION OF
MASTERBUILT SCALE: 1:1
DRW.BY:
MANUFACTURING IS
PROHIBITED.
SHEET 1 OF 1 Default
REV: --
DO NOT SCALE DRAWING General Tole
THE INFORMATION
CONTAINED IN THIS Masterbuilt Manufacturing, Inc.
STANDARD
DRAWING IS THE SOLE
X.
N/A
PROPERTY OF
1 Masterbuilt Ct
X.X
0.030
MASTERBUILT
Columbus, GA 31907
X.XX
MANUFACTURING. 0.015
ANY X.XXX
0.005
Phone: 706-327-5622 Fax: 706-256-5485
REPRODUCTION IN
X/X 1/32
PART OR AS A WHOLE
Degree 1°
WITHOUT THE WRITTEN
Unless Otherwis
PERMISSION OF
MASTERBUILT
MANUFACTURING IS
Adam Carter PROHIBITED. 4/28/2010
DATE:
DWG Name
21