Thermador Pro Harmony Série Instructions D'installation page 17

3. Grasp the door firmly on the ends of the door. Lift the
door up and out. There will be some spring resistance
to overcome.
4. Place the door in a safe and stable location.
Reinstalling the oven door before leak
testing the broil and bake burners
After replacing the bake burner orifices and the appliance
satisfactorily gas leak tested, the oven door, kick panel,
and the bottom front panel must be reinstalled.
1. Hold the door firmly in both hands.
2. Hold the door at a 30° angle from the closed position.
Insert hinges centered evenly into the hinge slots. The
hinges will securely hook into the slots when properly
installed. DO NOT force, bend or twist the door.
3. Open door fully to expose hinges, levers, and slots.
4. Flip the hinge forward until seated on the bracket. A
screwdriver may be required to carefully push the clip
back.
5. Close and open the door slowly to ensure it is
correctly and securely in place.
Removing the kick and front panels
1. Remove the kick panel screws using a T-20 torx
screwdriver.
2. Remove the front panel screws using a T-20 torx
screwdriver.
Page. 17