Controls - John Bean EHP System V Manuel D'utilisation

A
14
- EN
3.0-1
C
3.0-2

3.0 Controls

Before operating the machine, ensure that you have well
understood the operation and function of all the controls
(Fig.3.0-1).
A. Press down and release, WITH LEFT FOOT, the fi rst
pedal from the left: the column tilts backwards.
Do it again: the column tilts forward.
WARNING
DANGER OF BODY CRUSHING
TO MINIMIZE THE RISK OF SCRATCHING ALLOY
RIMS, THESE SHOULD BE CLAMPED FROM THE
OUTSIDE.
B. Press down and release, WITH LEFT FOOT, the
second pedal from the left: the clamps of the turntable will
retract. Do it again: the clamps will expand. If you press
the pedal prior to the end of the stroke and release, the
clamps may be stopped in any position.
WARNING
WATCH YOUR FINGERS AND LEGS!
C. Press down and hold, WITH RIGHT FOOT, the fi rst
pedal from the right: the turntable turns clockwise.
1. 3/4 down approximately, the turntable rotates at
the minimum speed. The torque is maximum in this
condition.
2. All the way down the turntable rotates at the
maximum speed (only for 220V).
Lift the pedal and the turntable turns counter-clockwise.
D. Open the bead breaker arm. Press down and hold,
WITH RIGHT FOOT, the second pedal from the right: by
doing this you operate the bead breaker blade and the
arm will move towards the machine. Release the pedal:
the bead breaker blade will retract.
E. The push button on the handle allows to release the
arms and position the mount/demount tool in the correct
position.
1. To unlock and let the slide with the tool go up: push
B
the button fi rmly with the forefi nger, in the direction of
the arrow (A Fig. 3.0-2).
2. To unlock and let the slide with the tool go down:
push the button with the thumb in the direction of the
arrow, until the resistance increases (B Fig. 3.0-2).
3. To lock: push the button fi rmly with the thumb (C
Fig. 3.0-2).
ATTENTION!
DANGER OF HAND CRUSHING