M
R
2.0-7
2.0-8
2.0-9
P2
S
Installing and Adjusting the original tire
changer tool
See Figure 2.0-7
18) Fix the tool previously removed from the tire changer
onto the second snap connection (P2) supplied with the
kit. Repeat the installation operations in points 8 to 11 of
these instructions.
19) Adjust as already described in points 14 and 15.
20) Tighten one of the two adjuster screws until the inside
of the claw of the tool is about 1/25" (1 mm) from the edge
of the rim, and at the same time, the edge of the tool is
fl ush with the edge of the rim on the opposite side of the
tool in the point shown in the diagram (Y Fig. 2.0-8).
21) Complete the adjustment by proceeding as indicated
in point 17.
22) Remove the rim from the turntable.
The kit is now ready for use.
You can use the standard tool for conventional rims or, if
you need to handle rims with a diameter greater than the
tire changer's rated capacity, rapidly substitute it with the
tool withthe +4 inch extension.
Tool change-over is extremely fast, allowing you to work
on rims with a diameter up to four inches larger than the
maximum permitted on your tire changer..
2.3 Hexagonal bar with off set roller Kit
EAA0507G98A (optional)
Installing the Horizontal hexagonal bar:
•
Insert the hexagonal rod with the roller in the lower
seat of the mobile guide, as shown fi gure 2.0-9.
WARNING: INCORRECT ROD INSTALLATION CAN
DAMAGE THE TYRE.
13
EN -