Turning The Tonometer Off; Error And Info Messages - Icare ic100 Mode D'emploi

Icare ic100 tonometer manual

TURNING THE TONOMETER OFF

Press the Select button (Figure 18) until the display shows the End-symbol (Figure 19).
If you do not use the tonometer, it will switch off automatically after 3 minutes.

ERROR AND INFO MESSAGES

The following messages may appear on the display:
MESSAGE DESCRIPTION
Battery charge is low.
The batteries are empty.
CHANGE
The probe did not move.
CHANGE
The probe did not move
properly for several times
during the measurement
sequence.
CLEAN
CHANGE
The probe did not touch the eye. Adjust correct measurement distance 4-8 mm. The
TOO FAR
Too short measurement
distance between the probe and
the cornea.
TOO NEAR
The probe did not move
properly. The probe did not
make clean contact with the
cornea, because the probe hit
REPEAT
an eyelid or eyelashes.
Internal error detected.
SERVICE
6
ACTIONS
Prepare to replace the batteries.
Turn the tonometer OFF by pressing Select button.
Replace the batteries.
Change the probe. The probe was twisted or
otherwise inserted incorrectly. To clear error
messages, press the Measure button, after which
the measurement can be repeated.
Remove and clean the probe base or replace it
with new one as instructed in Replacing/cleaning
the probe base. To clear error messages, press the
Measure button, after which the measurement can
be repeated.
measurement was taken from too far away.
Adjust correct measurement distance 4-8 mm. The
measurement was taken from too close. To clear
error messages, press the Measure button, after
which the measurement can be repeated.
Ensure that the eye is open, measure again. To
clear error messages, press the Measure button,
after which the measurement can be repeated.
Turn the tonometer OFF by pressing Select button.
Contact the seller to arrange sending the device for
service.