Noise/Vibration Information; Mounting And Operation - Würth BS 14-A LIGHT Traduction Des Instructions De Service D'origine

OBJ_BUCH-2226-001.book Page 14 Wednesday, July 9, 2014 1:50 PM
Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co. KG, PCM,
Reinhold-Würth-Straße 12–17
74653 Künzelsau, Germany
Marcel Strobel Dr.-Ing. Siegfried Beichter
Head of Product Head of Quality,
Management Authorized Signatory
Künzelsau: 09.07.2014

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 178.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745.
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Removing the battery
Inserting the battery
Mounting application tools
Reversing the rotational
direction
Setting the torque
Selecting the drilling position
Sound emission values determined according to
EN60745-2-1.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for differ-
ent applications, with different accessories or insertion tools or
is poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.

Mounting and Operation

Figure
1
2
3
4
5
6
Please Page
observe
179
179
179
180
180
181
14