Hotpoint Ariston AQUALTIS AQLF9D 69 U Instructions D'installation Et D'utilisation page 6

Masquer les pouces Voir aussi pour AQUALTIS AQLF9D 69 U:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

automatic dosing system intakes the correct amount of
detergent and fabric softener from the tanks for each
type of load and at the right time, guaranteeing optimal
washing results without wastage. The amount of
detergent/fabric softener can be modified manually by
pressing the DETERGENT and FABRIC SOFTENER
buttons (refer to "
prefer, the washing machine can also be used in the
"traditional" mode, i.e. by adding the detergent in the
dispenser; the machine will automatically detect the
detergent and will not use the tanks.
Pull out the detergent dispenser drawer up to the first
stop point to add the detergent (either liquid or powder
detergent), bleach or other additives (e.g. whiteners) and
the pre-wash detergent for washing in the "
mode (refer to "
” mode.
A
. Once the tanks have been filled
, the machine can run up to 60 cycles
before the detergent finishes
Turn the washing machine on by pressing the ON/OFF
button. The first wash cycle must be carried out without
laundry and by adding detergent in the detergent dispenser
(refer to "
mode); set the programme " "
(Cotton 90°) without pre-wash and without filling the tanks.
(*)
This washing machine is
equipped with two tanks:
one for liquid detergent
(either concentrated or
diluted) with a capacity of
approx. 5.5 l and another for
liquid fabric softener (either
concentrated or diluted) with
a capacity of approx. 3.5 l
.

The
"). If you
"
mode).
In order to fill the
: open the
dispenser drawer up to the
first stop point then press the
lever ( ) and open up to the
second stop point,
Open the detergent dispenser drawer in the "
" mode (refer to "
Slowly pour the detergent ( ) and fabric softener ( )
until the tanks are completely filled (
B
Start the wash cycle immediately after filling the tanks to
ensure that the dispenser is properly cleaned.The
respective icons
(for the detergent) and
fabric softener) will light up gradually to signal the level.
Select the density of the detergent added (either concentrated
or liquid) by pressing the appropriate button
Concentrated
Diluted
The machine will store the selection.
If no option is selected, the detergent intake option will
be pre-set to "
".
Use button
to set the amount of fabric softener that
will be automatically extracted by the machine:
If concentrated softener is used, we recommend
selecting the first level (
stepping up by a single position (
increase detergent intake.
If diluted softener is used, we recommend setting level
3 (
with 3 bars) and to then either increase/decrease
the amount of fabric softener to be extracted.
To exclude the use of fabric softener, press
bars disappear (also refer to "
").
").
).
C
(for the
.
with one bar) and, if necessary,
with 2 bars) to
until the

Publicité

Table des Matières
loading

Table des Matières