Hotpoint Ariston AQUALTIS AQLF9D 69 U Instructions D'installation Et D'utilisation page 7

Masquer les pouces Voir aussi pour AQUALTIS AQLF9D 69 U:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Once, at the end of a cycle, the level of detergent/fabric
softener falls below the level required for a successive
wash cycle, the display will visualise the relative
messages "
" or "
". If the tanks are not filled, the successive wash
cycles in
any intake of detergent.

after the machine's signal

If the compartments have been filled with detergent and
fabric softener, you may start using the machine (refer
to "
").
Powder
additives
The machine automatically intakes detergent on the
basis of the selected programme, wash load and water
hardness. However, the amount of detergent/fabric
softener used may be modified.
button: press to increase, decrease and to exclude
detergent intake.
button: press to increase, decrease and to exclude
fabric softener intake.
Tank cleaning cycles can either be automatic or pre-set
by the user.
" or "
will be carried out without
powder
The washing machine carries out an automatic cleaning
cycle during the rinse cycle if the level of detergent that
remains is insufficient for carrying out a
successive wash cycle.
Run the cleaning cycle (with empty drum) if you require
adding a different product to the previous one or if the
tanks have been incorrectly filled (e.g. fabric softener
has been erroneously poured into the detergent tank or
vice-versa). Press button
activate cleaning of the detergent tank, button
cleaning the fabric softener tank or button
cleaning both tanks. Keep pressing for a further 3 sec.
(the countdown "4-3-2-1" will appear in the top right
corner) until "
" pops up.
The cleaning cycle lasts about
empty; if not, the cycle will last longer. The icons
indicating that the tanks are empty will appear on the
display.
Pull out the detergent dispenser drawer up to the first
stop point
then pour the amount of
detergent and other additives (e.g. bleach) required for a
single wash cycle directly into the dispenser.
1
3
2
running a pre-wash cycle.
to be used whenever bleaching is
required
Select the programme and the compatible options on
the basis of the required need and type of load.
and hold for 5 sec. to
for
for
if the tanks are initially
use powder detergent
use powder
or liquid detergent. If the
latter is used, we
recommend pouring it into
the dispenser immediately
before starting the washing
machine and without
.

Publicité

Table des Matières
loading

Table des Matières