Candy PVD 604 Notice D'emploi Et D'installation page 50

INSTALLATION – ELECTRICAL CONNECTION
CONNECTING TO THE TERMINALS:
When connecting you must comply with the instruction given below.
. The installation must be protected by an appropriate fuse, see table page 51, and have
wires with sufficient cross-section to supply the appliance normally.
. The power supply cable must be selected according to the information of table page 51.
When connecting you should:
. Turn over the hob, glass side against the work top, taking care to protect the glass!
. Open the cover in the following sequence:
. find the two tabs located on the sides,
. put the blade of a flat screwdriver in front of
each tab, push in and press,
. remove the cover.
. Connect the power supply cable:
. comply with the information of the table page 51 and the markings on the terminal
board and install the shunts (the shunts, inserted in the terminal board, make a bridge
between two terminals),
. strip the end of each conductor and attach them to the terminals, complying with the
information given in the table page 51,
. unscrew the cable clamp,
. pass the lead through the cable clamp.
When you have finished the connection operation to the appliance terminals, tighten
the cable clamp and close the cover.
Note: make sure the terminal board screws are tight.
TERMINAL BOARD
50 -
Œ

)
) Shunts
) x 3
)
)