Connecting The Machine To The Power Supply; Foot Control - Janome 2212 Livret D'instructions

Janome 2212 Instruction Manual
2
6
www.toews.com
1
5
4

Connecting the Machine to the Power Supply

3
Before connecting the power cord, make sure the voltage and
frequency shown on the machine conform to your electrical
power.
1. Turn off the power switch.
2. Insert the machine plug into the machine socket.
3. Insert the power supply plug into the outlet .
4. Turn on the power switch to turn on the power and sewing
light.
1 Power supply plug
Outlet
3
Machine plug
5

Foot control

Sewing speed can be varied by the foot control.
The harder you press on the control, the faster the machine
runs.
Caution:
Do not place anything on the foot control, otherwise
the machine may start inadvertently.
Operating Instructions (for USA and Canada only):
The symbol "O" of a switch indicates the "off" position of
the switch.
For an appliance with a polarized plug (one blade wider
than the other):
To reduce the risk of electrical shock, this plug is
intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
The foot controller Model YC-482J-1 or TJC-150 is used
with this sewing machine.
8
Power switch
2
4 Machine socket
Foot control
6
2212 Owners Manual/ User Guide