Ayce MR04 Manuel D'utilisation page 37

B) Timer setting
a. In standby or charging mode, press " timing" twice to enter timer setting. At this
time, the digital tube displays the time that has been set before. "00:00" indicates
that there is no setting;
b. Press " " to enter hour setting. At this time, the left two digits of the digital tube
flash; press " charging" on the machine to increase the hour, and press " spot" to
decrease the hour;
c. Press " " again to enter the minute setting. At this time, the right two digits of
the digital tube flash, press "spot" to increase the minute, and press " charging" to
decrease the minute;
d. After setting, press " " again to confirm and save the settings.
C) Cancel timer setting
a. Disconnect the power from the machine, turn it on again after 3 seconds, and the
timer setting will be reset.
NOTE
a. The timer set on the machine display is based on the machine time. For
example, if the timer is set to 9:00, the machine will automatically start clean-
ing at 9:00 (machine time) every day. Therefore, please set the machine time
before setting the timer so that it matches the actual time and avoids unneces-
sary trouble.
b. Once set, the machine will automatically clean every day at the set time. The
timer needs to be reset when the power switch is turned off.
2 SET WITH THE REMOTE CONTROL
A) Timer setting
a. Press " " on the remote control to enter machine time setting, and press it again
to enter the timer setting. (The difference between the machine time setting and the
timer setting is whether " " on the machine is on; it is timer setting if on, and
machine time setting if off.)
b. Press " " on the remote control or swing the rocker to make the hour digital tube
cursor flash on the machine display, swing the rocker up and down to increase the
hour, and swing left and right to move the cursor.
c. When the cursor is flashing on the minute tube, press "
to confirm the setting.
" on the remote control
d. When setting the timer, press " " on the remote control to exit the setting. If you
don't press " " to confirm the setting, the machine will not save the settings.
B) Cancel timer setting
a. Make sure that the machine is working or in standby mode;
b. Press and hold the " " on the remote control for 3 seconds, the machine beeps
once, the time changes to "00:00", and the timer setting is canceled.
NOTE
a. When the machine panel displays the time, it means that the machine is in
the system time or the timer setting. The difference is that when the system
time is adjusted, the " " on the main unit panel is off;When the cleaning timer
is set, all the indicators will light up.
b. When setting the time, press "
and minute digits; press " " on the remote control to enter or exit the time
setting.
c. " " on the remote control is the same as "
WATER TANK USE
1. Push the mop cloth on the plate flatly.
2. Keep the water tank tilted, open the rubber plug and fill in water.
3. When the water seeps from both A and B, press the rubber plug into place.
4. Aim the mop cloth and water tank assembly at the positioning holes in the bottom
of the machine, and press in place.
5. Slowly place the machine on the ground; avoid flipping during the process.
6. Start the machine and mop the floor.
1
Rag
72 73
" on the remote control to confirm the hour
" on the main unit panel.
2
GB