Ayce MR04 Manuel D'utilisation page 36

POWER-ON
1. Make sure that the power switch is in "ON" position.
2. In standby mode, the machine starts working when you press the "
the remote control.
NOTE
If the machine is in sleep mode, press the "
remote control to switch the machine to standby mode, and press again to start
working.
Standby
Standby means that the machine is not working and is waiting for user operation;
access standby mode in the following method:
1. In working state, press the " " button on the machine or the remote control to
enter the standby mode.
2. Press the " " button on the remote control to stop the machine.
Sleep
If there is no operation for more than 60 seconds, the machine automatically enters
sleep mode.
Cleaning mode
Auto cleaning
In autocleaning mode, the machine automatically cleans
the room and adjusts the cleaning mode according to the
environments.
Tip:
Press the " " button on the remote control to enter auto
cleaning mode.
Spot cleaning
The spot cleaning mode is triggered in two ways:
1) When the machine detects the "severely afflicted area",
it will automatically enter spot cleaning mode.
2) Press the " " button on the remote control to enter
spot cleaning mode.
TIP:
It is recommended to use the spot cleaning mode when there is more garbage on
the ground.
" button on
" button on the machine or the
Edge cleaning
Press " "on the remote control to switch to edge
cleaning mode.
In edge cleaning mode, the machine will clean the
edges of the obstacle with its brush.
Zigzag cleaning
Press " " on the remote control to switch to the
Zigzag cleaning mode.
Zigzag cleaning is mainly used for quick and
efficient cleaning in large areas without furniture.
Smart broom cleaning
In standby mode, press the " " button on the
remote control to activate the smart broom mode.
Schedule cleaning
NOTE
The machine can only be set in standby or charging mode. If the machine is in
sleep state, press the " " button on the main unit or the remote control to
wake it up; if it is working, stop it first.
1 SET ON THE MACHINE DISPLAY
A) Machine time setting
a. In standby or charging mode, press the Timer button to enter the machine time
setting, and the digital tube displays the current machine time:
b. Press " " on the machine to enter hour setting. At this time, the left two digits
of the digital tube flash; press "charging" on the machine to increase the hour, and
press "spot" to decrease the hour;
c. Press " " again to enter the minute setting. At this time, the right two digits of
the digital tube flash, press " charge " to increase the minute, and press "spot " to
decrease the minute;
d. After setting, press " " again to confirm and save the settings.
70 71
GB