Ayce MR04 Manuel D'utilisation page 35

Charging dock
IR signal transmitting station
Top case
Power socket
Description of Remote Control Panel
ON/OFF
Timer setting
UV lamp
Introduction to Remote Control Operation
Turn on/off the machine
Schedule cleaning. For details, see Timer setting on 71-73.
UV light on/off
Return to charge mode
Switch cleaning mode; see 69-70 for specific operation methods
Spot cleaning
Working status signal indicator
IR pilot signal transmitting
window
Charging pins
Direction Control Button
Return to Charge mode Button
Mode Settings Button
Spot Cleaning Mode
OPERATION GUIDE
Charging batteries
1. Place the charging dock at the side of the wall and remove all obstacles within 1m
on left and right sides and 2m in front of the charging dock, as shown below.
2. Turn on the machine power switch, the panel display light turns on, and the
machine enters standby mode.
3. You can place the main unit in front of the charging dock to facilitate the docking
of the charging terminals. Press the "
machine automatically find the charging dock.
NOTE
When the battery is low in working mode, the machine will automatically find
the charging dock.
To extend battery life effectively:
1. Please charge the machine for 12 hours before using it for the first time;
2. When the battery is low, please charge as soon as possible;
3. When the cleaning is completed or the battery is too low, the machine will
automatically find the charging dock to charge;
4. If the machine won't be used for a long time, fully charge the battery, take it out
and place in a well-ventilated and dry place;
5. If the machine won't be used for more than 3 months, please charge the machine
for 12 hours.
68 69
" button on the remote control to make the
GB