Ayce MR04 Manuel D'utilisation page 38

3
A B
5
NOTE
1. It is recommended to fill in 80% water for the first time to ensure better
seepage and mopping efficiency (only for the first time).
2. If it is not necessary to mop the floor, be sure to remove the water tank and
mop cloth assembly or pour out the water in the water tank.
3. It is not recommended to carry out wet-mopping operation with water tank
on wooden floor when unattended in order to avoid damage to the wooden floor
due to excessive water.
4. It is recommended to use pure water to avoid water quality problems affect-
ing the water discharging of the tank.
4
6
MAINTENANCE
DUST BIN AND FILTER CLEANING
Please empty the dust bin after each use; the specific steps are as follows:
Press
1. Press the "Dust bin" mark on the middle cover to open it
4. Open the dust cover and remove
3. Take out the HEPA
the primary filter
6. Rinse the dust bin and primary filter
with water and clean the HEPA with
cleaning tool
TIP:
1. Check whether the side brush is damaged or whether there is any foreign matter
on it.
2. Clean the side brush with the cleaning tool or rag.
3. If curling or deformation occurs, remove the side brush and immerse in warm
water for 1-2 minutes.
4. Replace the side brush in time if it is damaged and can't be used:
NOTE
1. It is recommended to wash the filters after using for 15-20 days. The maxi-
mum life of the HEPA is 24 months.
2. Make sure that the filters are dry before installation.
3. HEPA and primary filter are all replaceable accessories.
4. Do not expose the filters to sunlight.
74 75 GB
2. Take out the dust bin
5. Pour out the garbage in
the dust bin
7. Reinstall the primary filter and HEPA
back into the dust bin