Electrical Connections; Connecting The Appliance To The Power Supply - Progress PM276 Notice D'utilisation

SAFE USE OF THE APPLIANCE
If fitting the microwave in position B or C
(see diagram on page 26):
• The cupboard must be a minimum of 500 mm
(E) above the worktop and must not be
installed directly above a hob.
• This appliance has been tested and approved
for use near domestic gas, electric and
induction hobs only.
• Sufficient space between hob and microwave
should be allowed to prevent overheating of
microwave oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans when
the microwave oven is operating.
• Care should be taken when attending to the
microwave oven while the hob is on.
CONNECTING THE APPLIANCE TO
THE POWER SUPPLY
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or it
should be possible to isolate the oven
from the supply by incorporating a
switch in the fixed wiring in accordance
with the wiring rules.
• The socket should not be positioned
behind the cupboard.
• The best position is above the cupboard,
see (A).
• Connect the appliance to a single phase
230 V/50 Hz alternating current via a
correctly installed earth socket. The socket
must be fused with a 10 A fuse.
• The power supply cord may only be
replaced by an electrician.
(A)
• Before installing, tie a piece of string to the
power supply cord to facilitate connection to
point (A) when the appliance is being installed.
• When inserting the appliance into the high-
sided cupboard, DO NOT crush the power
supply cord.
• Do not immerse the power supply cord or
plug in water or any other liquid.

ELECTRICAL CONNECTIONS

WARNING!
THIS APPLIANCE MUST BE
EARTHED
The manufacturer declines any
liability should this safety measure
not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, you must call your
local ELECTROLUX service agent.
27
ENGLISH