switel WTF 727 Mode D'emploi page 66

Operating the Walkie−Talkies
Resuming channel scanning
X or Y
Excluding a channel
32
If a channel found during the channel scanning process should
not be considered for subsequent use, it can be excluded. All
the channels are taken into consideration again when a new
channel scan is started. During the time that the walkie−talkie is
temporarily stopped on the unwanted channel, press and hold
the X / Y key for 3 seconds to exclude that channel.
a, 3 sec. X or Y
Transmit ringing tone
The ringing tones indicate to other subscribers that you want to
talk to them. A condition for this is that the other subscribers are
using the same channel and CTCSS/CDCSS code.
T
Selecting/Deactivating the ringing tone
There are 10 ringing tones available for selection. To deactivate
the ringing tone, select the setting 0" (zero).
3 x M
X or Y, P
Monitor
The Monitor function enables the search for weak signals on the
channel currently set. If you receive an external signal, switch to
a free channel. Always communicate with other subscribers on a
free channel to prevent interference.
a, N
b, N
66
Resume channel scanning
The channel is excluded and
channel scanning automatically
resumed
Send ringing tones
Activate programming mode
Select the ringing tone and
confirm it
Monitor the channel
End the monitoring function