Product Certifications; Packaging And Supplied Accessories; Transport And Handling - Ariston 200 Mode D'emploi

Heat pump water heater - TECHNICAL INFORMATION FOR INSTALLERS

1.4 Product certifications

The CE marking of the appliances attests its conformity to the following EC Directives, of which it satisfies the
essential requisites:
- 2006/95/EC on electrical safety LVD (EN/IEC 60335-1; EN/IEC 60335-2-21; EN/IEC 60335-2-40);
- 2004/108/EC on electromagnetic compatibility EMC (EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3);
- RoHS2 2011/65/EU on restriction of use on certain hazardous substances in electrical and electronic equipment
(EN 50581).
- Commission Regulation (EU) no. 814/2013 on ecodesign (no. 2014/C 207/03 - transitional methods of measurement
and calculation)
Verification of performance is carried out through the following technical regulations:
- EN 16147;
- CAHIER DE CHARGE_103-15/B_2011 Chauffe-eau Thermodynamiques pour la marque NF élettricitè
performance;
- 2014/C 207/03 - transitional methods of measurement and calculation
This product complies with:
- REACH Regulation 1907/2006/EC;
- Commission Delegated Regulation (EU) no. 812/2013 (labelling)

1.5 Packaging and supplied accessories

The appliance is anchored to a wooden pallet and is protected with polystyrene edge protectors, cardboard and a plastic
transparent film on the outside; all the materials are recyclable and eco-compatible.
The following accessories are included:
- Belt for handling the water heater (to be removed once the product is installed).
- Connection pipe for condensation water.
- Instruction manual and warranty documents.
- Two 3/4" dielectric coupling and joints.
- Energy label and product fiche.
- 2 air connections.

1.6 Transport and handling

Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of damage
appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.
WARNING! The appliance should be handled and stored in a vertical position. The product may be handled in
a horizontal position only for short distances, while resting on the rear end indicated; in this case, wait at least
3 hours before starting the appliance once it has been correctly repositioned in a vertical position and/or
installed; this is to ensure that the lubricating oil inside the refrigeration circuit is suitably distributed and to
avoid damages to the compressor.
The packaged appliance may be handled either manually or with the aid of a forklift truck, while ensuring that the above
indications are observed. It is advisable to keep the appliance in its original packaging until installing it in its chosen
location, particularly when construction work is under way on-site.
Upon removing the packaging, check whether the appliance is intact and that no parts are missing. In the event of
defects or missing components, notify the dealer within the time limits specified by the law.
WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.
When transporting or handling the appliance after the initial start-up, observe the aforementioned indication concerning
the allowed tilt angle and ensure that all water has been drained from the tank. Should the original packaging be missing,
provide an adequate protection for the appliance to prevent any damages, for which the manufacturer shall not be held
liable.
60