7. Installation of the camera
Proceed as follows when installing the camera:
1. Select a suitable place on the ceiling of the room where you would like to
mount the camera.
2. Unscrew the fixing screw of the dome cap (anti clockwise):
3. Connect the video cable (recommended cable type: RG59) to the BNC video
out (1) of the camera and to the following connected video unit. The maximum
cable length should not exceed 150 m.
4. Connect a 12V DC power supply to the power input of the camera (2).
5. Hold the camera at the location where you want to mount it. Check the
orientation and angle of the camera.
6. Remove the plastic dome from the housing by simply pulling the black cap
downwards.
7. Change the orientation of the camera module if necessary by loosening the
fixing screws at the positions marked with the arrows, modifying the inclination
and direction of the camera module, and then tightening the fixing screws
again.
Tighten the fixing screws again.
8. Fasten the Eyseo mini-dome camera to the desired
mounting location using the supplied screws and screw
on the plastic dome again. If needed you can use and
install the supplied ceiling/wall mount bracket.
Fixing screw
5