Precision Cooking - Cafe DISTINCT BY DESIGN CHS900M Manuel De L'utilisateur

Cuisinières à induction à commandes avant
Masquer les pouces Voir aussi pour DISTINCT BY DESIGN CHS900M:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Surface Units (Cont.)
Using the Warming Zone
WARNING
FOOD POISON HAZARD: Bacteria may grow in food at
temperatures below 140°F.
■ Always start with hot food. Do not use warm setting to
heat cold food.
■ Do not use warm setting for more than 2 hours.
The WARMING ZONE, located in the back center of
the glass surface, will keep hot, cooked food at serving
temperature. Always start with hot food. Do not use to
heat cold food. Placing uncooked or cold food on the
WARMING ZONE could result in foodborne illness.
To use the WARMING ZONE:
Press the WARMING ZONE pad, select the desired level
(1, 2 or 3) using the number pads, and press start.
How To Synchronize Left Elements
The Sync Burners feature is only intended for cookware
that completely spans both burners.
To Turn On
Hold the Sync Burners pad for about half a second to
connect the two elements. Operate either element as
described in Operating the Cooktop Elements to adjust
power level.

Precision Cooking

The Precision Cooking feature allows precise
temperature control for improved results. This feature
may be used with the Precision Cooktop Sensor on
the front left burner or with compatible Bluetooth paired
cooking devices on any burner. Only one burner may
operate in precision cook mode at a time.
8
To turn off the WARMING ZONE:
Press the WARMING ZONE pad.
NOTE: Cancel/Off will NOT turn off the warming zone.
For best results, all foods on the WARMING ZONE
should be covered with a lid or aluminum foil. When
warming pastries or breads, the cover should be vented
to allow moisture to escape.
The initial temperature, type and amount of food, type of
pan, and the time held will affect the quality of the food.
Always use pot holders or oven mitts when removing
food from the WARMING ZONE, since cookware and
plates will be hot.
NOTE: The surface warmer will not glow red.
To Turn Off
1. Touch the On/Off pad on either element to turn off the
Sync Burners.
or
2. Touch the Sync Burners to turn both elements off.
Pairing a Bluetooth
To pair a Bluetooth device, refer to Settings section.
Device
®
49-2000387 Rev. 4

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Distinct by design chs90xm

Table des Matières