Klarstein FLORIDA JERKY Mode D'emploi page 34

EN
34
Manual mode
Turn the knob in the middle to the hand symbol. The symbol will light
up. Press the knob to set the temperature. Turn the knob to select
a temperature between 35-75°C. After you have set the desired
temperature, press the knob to confirm. You can now set the operating
time to 1-99 hours. Turn the knob to the desired value and press to
confirm.
• If you want to dry with infrared light, turn the knob to the symbol
and press to confirm. The appliance will now start with the selected
temperature and time. In addition, the infrared light comes on.
• If you want to dry without infrared light, turn the knob to the symbol
and press it to confirm. The unit will now start with the selected
temperature and time. The infrared light remains off.
• The program can be adjusted at any time during operation.
Note: If you open the door of the automatic dryer during operation, the backlight
turns off and the temperature display shows [F1]. If you close the door again within 5
minutes, the set program is continued.
Switching off the device
Press and hold the controller to turn off the unit. All displays will slowly go out.
Error Messages
F1 The door's open.
F2 The temperature has exceeded the permissible limit. As soon as the unit has
cooled down, operation is resumed.