Front Panel Connections; Connections - AMETEK Programmable Power Sorensen XPF Série Mode D'emploi

Front Panel Connections

The load should be connected to the positive (red) and negative (black) terminals marked
OUTPUT. The OUTPUT terminals are rated at 30A.
Remote sense connections to the load, if required, are made from the positive (+) and
negative (−) SENSE terminals. Switch the LOCAL/REMOTE switch to REMOTE when remote
sensing is required. Switch back to LOCAL when remote sensing is not in use.
The terminal marked
Rear Panel Connections (XPF 60-20P & XPF 60-20A only)
XPF 60-20P
SKA60-20K DC Kower Nupplt
REM LAN CC CV UNREG
V
A
MAIN FINE
is connected to the chassis and safety earth ground.
60V max
V
20A max
A
V I SETTINGS
VIEW LOCK
(LOCAL)
Hold to Cancel
OUTPUT
OVP
ON
Hold
to Set
SENSE
REM
LOCAL
XPF 60-20A

Connections

9